Ultrasound Probe Disinfection: Guidelines Agree on Covers and Sterile Gel, Not on Disinfection Level

Ultrasound Probe Disinfection: Guidelines Agree on Covers and Sterile Gel, Not on Disinfection Level

By Ivan Urits, MD – Board Certified in Anesthesiology and Pain Medicine

Published May 6, 2025 | Category: Pain Medicine

Ultrasound guidance is increasingly used for pain injections and nerve blocks. Because the probe sits near the needle insertion site, it can carry germs into the skin if not properly cleaned. A 2024 review in the Australasian Journal of Ultrasound in Medicine examined international guidelines on how ultrasound probes should be disinfected for needle procedures.

This summary is based on the published abstract. Read the abstract on PubMed

What the authors did

The authors identified 13 guidelines published between 2013 and January 2024 and evaluated the evidence behind their recommendations on probe disinfection for percutaneous procedures.

What they found

  • No guideline was based on high-quality evidence. Recommendations relied on expert opinion, infection control principles, other guidelines and retrospective infection data.
  • All guidelines supported using probe covers and sterile ultrasound gel during ultrasound-guided needle procedures.
  • The minimum level of disinfection varied: seven guidelines recommended high-level disinfection, four recommended low-level disinfection, and two did not specify.
  • The standard classification system used to decide disinfection levels led to inconsistent conclusions in this setting.

The authors conclude that risk-based assessment will remain central to recommendations, considering all the steps taken to prevent infection.

Why this matters

Infections after injections are rare but can be serious, especially near joints and the spine. Simple, consistent practices, such as sterile gel, probe covers and appropriate probe cleaning, reduce risk across the board.

Limitations

This is a narrative review of guidelines, not a study of infection outcomes. Recommendations may change as better evidence becomes available.

Safety takeaways: how to apply it

For pain physicians and procedure teams

  • Use a sterile probe cover and sterile, single-use gel for every ultrasound-guided needle procedure.
  • Clean and disinfect probes after each use according to your institution's policy and the manufacturer's instructions.
  • Prepare the skin carefully and keep the needle path away from non-sterile gel.

For hospitals, clinics and safety leaders

  • Write clear probe-disinfection and gel policies, and audit compliance.

For patients and families

  • It is reasonable to ask how ultrasound equipment is cleaned and whether sterile covers are used.

Reference

  1. Peters N, Williamson F, Eley V. Ultrasound transducer disinfection for percutaneous procedures: A review of the evidence supporting guideline recommendations. Australas J Ultrasound Med. 2024 Nov;27(4):242-250. doi:10.1002/ajum.12408. PMID: 39734617. PubMed: https://pubmed.ncbi.nlm.nih.gov/39734617/

This article is educational information, not legal or medical advice.

Previous
Previous

Epidural Steroid Injections Can Be Performed Safely in Severe Lumbar Spinal Stenosis

Next
Next

Survey Shows Wide Variation in How Pain Physicians Handle Blood Thinners Before Procedures