Measuring Radiation Exposure During Minimally Invasive Lumbar Decompression

Measuring Radiation Exposure During Minimally Invasive Lumbar Decompression

By Ivan Urits, MD – Board Certified in Anesthesiology and Pain Medicine

Published January 28, 2025 | Category: Pain Medicine

Minimally invasive lumbar decompression (the mild® procedure) treats spinal stenosis caused by a thickened ligament in the back of the spinal canal. It is performed through a small incision under live X-ray (fluoroscopy) guidance, which exposes both the patient and the physician to radiation. A prospective study published in Pain Practice measured that exposure.

This summary is based on the published abstract. Read the abstract on PubMed

What the authors did

One physician performed the procedure on 41 patients at a large academic pain center between October 2019 and December 2021 while wearing a radiation monitor. The team measured fluoroscopy time and radiation dose for each case and for each side and level treated, and compared the results with other fluoroscopy-guided pain procedures.

What they found

  • Fluoroscopy time averaged 2.1 minutes per side and level treated.
  • The average total patient dose was about 142 mGy per procedure.
  • Per side and level treated, the physician's estimated exposure was about 4.1 mrem to deep tissue, 2.9 mrem to the eyes and 14.7 mrem to the skin.
  • A physician would need to perform about 610 procedures a year to exceed the annual exposure limit.
  • Compared with other fluoroscopy-guided pain procedures, exposure was low.

Why this matters

Radiation risks are cumulative over a career, especially for the eyes and hands. Knowing the exposure from each procedure type helps physicians and safety officers plan protection, monitor doses and set realistic expectations for patients.

Limitations

All procedures were performed by one experienced physician at one center, so exposure may be higher for less experienced operators or different equipment. Only 41 patients were studied.

Safety takeaways: how to apply it

For pain physicians and procedure teams

  • Wear a dosimeter, lead apron, thyroid shield and protective eyewear for every fluoroscopy procedure.
  • Use pulsed fluoroscopy, collimation and the shortest practical imaging time.
  • Step back from the X-ray source whenever possible.

For hospitals, clinics and safety leaders

  • Review dosimetry reports regularly and investigate unusually high readings.

For patients and families

  • Ask how the team keeps radiation as low as possible during your procedure.

Reference

  1. Mekhail N, Topalsky K, Templeton E, Armanyous S, Prayson N, Olde C, et al. Patient and physician radiation exposure during minimally invasive lumbar decompression: A prospective assessment of X-ray exposure risks. Pain Pract. 2024 Apr;24(4):600-608. doi:10.1111/papr.13329. PMID: 38069541. PubMed: https://pubmed.ncbi.nlm.nih.gov/38069541/

This article is educational information, not legal or medical advice.

Previous
Previous

Protecting Pain Physicians From Radiation: What the Evidence Shows

Next
Next

Lessons From Spinal Cord Stimulator Malpractice Claims