Key Safety Rules for Epidural and Sacroiliac Joint Injections

Key Safety Rules for Epidural and Sacroiliac Joint Injections

By Ivan Urits, MD – Board Certified in Anesthesiology and Pain Medicine

Published March 3, 2026 | Category: Pain Medicine

Epidural steroid injections and sacroiliac (SI) joint procedures are performed millions of times a year. Serious complications are rare but can be devastating. In 2025, the International Pain and Spine Intervention Society (IPSIS) published concise safety practices for these procedures in Interventional Pain Medicine.

This summary is based on the open-access full text. Read the article on PubMed

What the authors did

Expert groups wrote safety practices for epidural access and injection (cervical, thoracic, lumbar and caudal), SI joint injection, sacral lateral branch blocks and sacral lateral branch radiofrequency ablation.

Key recommendations

  • Be ready for emergencies: Resuscitation drugs, monitoring equipment and oxygen must be available for every epidural procedure.
  • Use fluoroscopy as the recommended image guide, with the lowest reasonable radiation dose.
  • Review imaging before cervical interlaminar injections to confirm there is enough space behind the spinal cord. Do not inject higher than C6-7, and preferably at C7-T1 or below. If C7-T1 is severely narrowed, consider a lower level.
  • Check depth with the right view. For interlaminar injections, the contralateral oblique view is better than the lateral view for seeing the needle tip.
  • For transforaminal injections, inject contrast through extension tubing under live fluoroscopy, with or without digital subtraction, before any medication. Treat any vascular flow as dangerous, and stop if arterial flow is suspected.
  • Use non-particulate dexamethasone first for lumbar transforaminal injections, and do not mix it with ropivacaine.
  • Blood thinners: Epidural injections carry intermediate to high bleeding risk, and decisions about stopping blood thinners should include the prescribing physician, since stopping them also carries risk. SI joint injections and sacral lateral branch procedures are low risk, and blood thinners usually do not need to be stopped.
  • SI joint volume: Keep total volume at or below 2 mL to avoid spread to nearby nerves.
  • Aftercare: Monitor patients, give written instructions, and tell people with diabetes to watch their blood sugar.

Why this matters

These practices address the main causes of catastrophic injury after spine injections: injection into an artery, needle placement into the spinal cord, and bleeding. Most of the protective steps take seconds and cost little.

Limitations

These are expert recommendations, not new research. Some areas, such as ultrasound guidance and blood thinner management, are still evolving.

Safety takeaways: how to apply it

For pain physicians and procedure teams

  • Review MRI or CT before cervical and transforaminal injections.
  • Use live contrast injection before any medication, and non-particulate steroid for transforaminal injections.
  • Coordinate blood thinner decisions with the prescribing physician.

For hospitals, clinics and safety leaders

  • Stock resuscitation equipment in every procedure room and run regular drills.

For patients and families

  • Tell your physician about every blood thinner and supplement you take, and report new weakness, numbness or severe pain after an injection.

Reference

  1. Klessinger S, Schuster NM, Waring PH, Vorobeychik Y, Schneider BJ, Johnson SC, et al. Safety practices for interventional pain procedures: Epidural and sacroiliac interventions. Interv Pain Med. 2025 Jun;4(2):100579. doi:10.1016/j.inpm.2025.100579. PMID: 40242296. PubMed: https://pubmed.ncbi.nlm.nih.gov/40242296/

This article is educational information, not legal or medical advice.

Previous
Previous

Severe Neck Stenosis Calls for Careful Planning, Not Automatic Refusal, for Epidural Injections

Next
Next

Recognizing and Treating Neuromodulation Device Infections Early: The DETER Recommendations